Jump to content

Imposition Question


Velotypo

Recommended Posts

  • 4 years later...

Has this changed over the several iterations of FusionPro and it's Imposition programming since 2017?

 

Asking because I have to do a job that MUST be run as a saddle stitch job with a 1/4" gutter down the middle. I know that I can design each of the booklet pages with an extra 1/4" alternating along each side to accomplish that but I would like to be able to do that just in the imposition. If that spacing needs to change to 1/8" or to 3/8" or something else besides the 1/4" then the entire job has to be scrapped and started again from the artwork design phase.

Link to comment
Share on other sites

Not much has changed regarding basic imposition functionality in that time frame, unfortunately. We do have a number of imposition enhancements on our list, but I can't say when they'll be implemented.

 

Regarding your specific case, I'm not sure I completely understand what you're trying to do. A mock-up of what output you're trying to accomplish would help.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...