Jump to content

Need Speed!


Fotorecord

Recommended Posts

New user trying to print 4 x 5 postcards 8-up on 12 x 18 sheet with variable data on both sides.

Using mac for file set-up / FP

Transfer to Command workstation EFI Fiery for output on Xerox 700.

Daily volume: 2000 - 5000 cards

What is the fastest way to rip these through the Fiery?

We are not having any luck here with spooling/output speed to 700.

Link to comment
Share on other sites

New user trying to print 4 x 5 postcards 8-up on 12 x 18 sheet with variable data on both sides.

Using mac for file set-up / FP

Transfer to Command workstation EFI Fiery for output on Xerox 700.

Daily volume: 2000 - 5000 cards

What is the fastest way to rip these through the Fiery?

We are not having any luck here with spooling/output speed to 700.

Link to comment
Share on other sites

Hello,

 

Do you have a free-standing Fiery controller sitting next to your Xerox 700 or is the Fiery controller embedded in the press?

 

If you have a free-standing Fiery, try outputting PPML from FusionPro and then loading the resulting .ZIP file that is generated into the CWS just like any other job (using manual job import or using the Fiery Hot Folders solution).

 

If you have an embedded controller in the press, you likely can only support PostScript or PDF - neither of which will RIP very fast.

 

hth

Link to comment
Share on other sites

I'm not familiar with the E10-02. I would suggest contacting the folks that support your hardware and asking what print file formats are supported on your particular Fiery. I would specifically ask if your Fiery supports PPML.
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...