Jump to content

CSzydlowski

Registered Users - Approved
  • Posts

    13
  • Joined

Converted

  • Location
    Hamburg, NY

Converted

  • Occupation
    Programmer, Mailing Services

Converted

  • FusionPro Products
    No

CSzydlowski's Achievements

Apprentice

Apprentice (3/14)

  • First Post Rare
  • Collaborator Rare
  • Conversation Starter Rare
  • Week One Done
  • One Month Later

Recent Badges

10

Reputation

  1. Nevermind, I got it and the demo is up and running.
  2. Hello All, I'm looking for some help that is utterly basic. I went through the store training in 2010 and created maybe 5 projects right away and then haven't touched it again since. There were 2 other people in the office that handled this but neither are currently available for different reasons. Anyways, we have a client that wants to see a demo of a very basic 10 page, 4x6 single sided print job. Each page would be a picture uploaded by the user. So the template would need to have a rule for each page that ties out to an uploaded picture. I'm hoping someone can upload a starting point for me of 1 page with the rule as the store would need it. I can then replicate out the other 9 pages. I'm going to pour over the forums in the meantime to see if I can relearn the process.
  3. So long story short a shell got printed 4 up but it was printed as a work and turn instead of all 4 fronts on one side and all 4 backs on the other. That said, i'm hoping there is a way to impose my document from the current 6.5" x 6.5" to 4 up on 14" x 14" sheets with the press sheet having 2 fronts in the left 2 positions and the backs on the right 2 positions, and to make matters worse it's a duplex variable document, so the opposite is the case on the other side of the press sheet. This is a typical work and turn press sheet but wanted to make sure I was crystal clear on the layout. Plus this is supposed to mail tomorrow so I'm under a time crunch to get these composed and printed today.
  4. I am using this rule to change a page at the field change to add a cover page to a section. FusionPro.Composition.SetBodyPageUsage("Cover", FieldChanged("MemberIDend")); This works as single pages but not in an imposition. It repeats the "Cover" page in the composed file. Any help would be appreciated
  5. I'm sure that I am the culprit, but I've attached my collected job and hopefully someone can help me. Only the first record is outputting, although it says it is running through all of the pages.307974_Pages.zip
×
×
  • Create New...