Jump to content

allie_pipmarketing

Registered Users - Approved
  • Posts

    2
  • Joined

Converted

  • FusionPro Products
    No

allie_pipmarketing's Achievements

Newbie

Newbie (1/14)

  • First Post Rare
  • Week One Done
  • One Month Later
  • One Year In
  • Conversation Starter Rare

Recent Badges

10

Reputation

  1. Thank you very much! I knew there had to be something to add to the rule.
  2. Hello, I am new to FusionPro Desktop and the majority of work we do is variable numbering. I have two questions. 1) Setting a starting number - I followed the directions on page 68 of the manual and it shows that the way to "select" your starting number is to select it in the Input tab of the Composition Settings (the "From:" range) and when I do this, I get the sequence starting at 1. I am currently working on a job we did previously in Print Shop Mail so I'm redoing it in FPD. The starting number I need is 16,001 thru 18,000. I set those ranges and it "skipped" the previous numbers as it processed the job (took LOTS OF TIME) but then it output the starting number as 1 anyway. I am used to PSM where I select the range, steps, etc. in the expression. Is there some way to select these within the rules? (I set it up using empty rules like the manual suggested) Is there a trick that the manual doesn't share? I am also concerned about the time it takes "skipping" the numbers not in the sequence range as we have one job that we run 10,000 at a time and the numbers start well up into the 800,000s right now. 2) Leading Zeros - Is there a way to do leading zeros in the rules? Many of our previous numbering jobs (from PSM) require leading zeros. The only way I could find to do it was to use it as a part of the rule ( return "000" + like the manual example states) which is fine unless the numbers span from from tens to hundreds, etc. Thank you in advance! Allie PIP Marketing Group
×
×
  • Create New...