Jump to content

copypickup

Registered Users - Approved
  • Posts

    2
  • Joined

Converted

  • FusionPro Products
    No

copypickup's Achievements

Newbie

Newbie (1/14)

  • First Post Rare
  • Week One Done
  • One Month Later
  • One Year In
  • Conversation Starter Rare

Recent Badges

10

Reputation

  1. I'm running one ream of 2-part carbonless forms. Each set of two part will have two forms on it. Therefore I need the numbering to go like this: 4101, 4102, 4101, 4102, 4103, 4104, 4103, 4104 That way, when I do multiple pages per sheet from the PDF, pages 1 and 2 will have the same numbers, 3 and 4 will have the same numbers, etc. so the carbon copy will be the same invoice number as the one on the white copy ahead of it. I hope this explains it better.
  2. Hi everyone. I basically just purchased Fusion Pro and my first job is giving me trouble. I found through searching the ability to do 2-part carbonless forms using the following javascript: FusionPro.Composition.repeatRecordCount = 2; The issue is that the forms will be run 2-up. Each form will be cut to 8.5x5.5. I have one form created as the base at 8.5x5.5 and I can get it to number it properly, but when running them 2-up from Acrobat the correct numbers will not fall behind each other for the carbonless. Can anyone provide a suggestion? Thanks!
×
×
  • Create New...