Jump to content

larkmenaerts

Registered Users - Approved
  • Posts

    2
  • Joined

Converted

  • FusionPro Products
    No

larkmenaerts's Achievements

Newbie

Newbie (1/14)

  • First Post Rare
  • Week One Done
  • One Month Later
  • One Year In
  • Conversation Starter Rare

Recent Badges

10

Reputation

  1. thank you verry much for the quick reply. This gives me a good feeling about this community. There is one problem, i made a new rule using your code with my own data field. When i ask to validate i notice 1 digit is trimmed off my value. That's good but it is the on the wrong side. The digit is trimmed of in the front of my complete number and it needs to trim the last digit. How can i adjust this minor error? One other thing where i doubt this will work on my version "...and then use the rule as your field to input into the Barcode Rule...". I do not seem to have an option to do this?
  2. I am new to fusion pro and variable data in the whole. Like the software so far and seen a lot of the online movies about the use of it. I encountered a problem i can not solve yet with my little knowledge so i thought to give it a shot on the forum. My customers delivers a clean exel file with the info i need to create a list of EAN13 barcodes. I thought an Ean13 code should have 12 numbers as input. My customers uses 13 numbers in the exel file. One number to much? Yes and no, it seems that the last control number that is normally added with barcode creation is allready added to the input file. The barcode software we used to have ignores the last controlnumber when added with input. Fusion pro simply does not create the barcode because there is one number to many. Is it possible to create a rule, based on the EAN13 barcode rule, that erases the last number or something else to solve this problem. We all know that asking the customer to use 12 numbers instead of 13 is not an option. I have no knowledge about Javascript !
×
×
  • Create New...