Jump to content

prescottsnowprint.com

Registered Users - Approved
  • Posts

    2
  • Joined

Converted

  • FusionPro Products
    No

prescottsnowprint.com's Achievements

Newbie

Newbie (1/14)

  • First Post Rare
  • Week One Done
  • One Month Later
  • One Year In
  • Conversation Starter Rare

Recent Badges

10

Reputation

  1. I've had this problem come up quite a few times where my composed output file does not seem to be reading the trim box of my document correctly. Composing shifts my artwork a quarter inch to the right and down leaving no bleed on the upper left. The only fix that I have found is to place my PDF in InDesign and output a new PDF and build on this. I have checked and rechecked my boxes a dozen times and still have the same problem. Any help is appreciated. I tried to upload my files with this post but kept receiving a database error. The only file that worked was my .fpi file. 4x6, 12x18, 4up Duplex BLD.fpi
  2. I can see that this thread is very old but I thought I would reply anyway. I had a similar situation of needing 5 proof samples for each of several different variable letters. In the past I have always output one at a time and then combined the output pdfs. This was very time consuming especially if there were rounds of corrections. I used a modified version of esmith's code and it worked like a charm. This is going to save me a ton of time. The only thing I wish I could figure out is how I could get the different versions to appear in order one after another instead of mixed up (this is because the data is in presort mailing order). Thanks for the help!
×
×
  • Create New...