Custom Commands for Digimaster PS

[aaroncorson]

Does anyone have a list of custom command codes for the Digimaster other than the ones that are included with the software. Specifically I am looking for a command that will tell the machine to jog (offset) at certain points in the file.

I only have the staple finisher, not the stacker, which I have been told is part of the problem, since the stacker would allow me to do this without a command.

Example: I created a 4 page document and output the first 10 records to a Digimaster PS file and I would like the finisher to offset every 4 page set, but instead it prints the entire 40 page file as one set.

Other suggestions on how to do this are appreciated as well. Thanks in advance!

[aaroncorson]

Working with Konica, we have come up with a solution to the problem. Hopefully this will help someone else so they don't have to go thru everything I did.

The correct command code for the Digimaster is..

%KDKPeSubset: # # # #

with the # sign representing the first page of each new set.

In the example in my OP we would us the following command code

%KDKPeSubset: 5 9 13 17 21 25 29 33 37

Then set the print driver to offset stack and it works like a charm.
You can also use the same command to subset staple.